Submitted by James Klim DDS, CADStar Host on 01/30/2012 - 7:16pm
This is the week of sheet-rocking the new Klim practice and CADStar CEREC training & mentoring home. Looking forward to CADStar’s future training options. One of my objectives in addition to training CEREC, is full practice integration, materials, and support systems. Even though I use CEREC technology to fabricate my restorations, my success is more about patient relationships, clinical diagnosis, support systems, and placement protocols. Read more
Submitted by James Klim DDS, CADStar Host on 01/29/2012 - 3:38pm
Submitted by James Klim DDS, CADStar Host on 01/24/2012 - 10:42pm
Completed this CEREC LAVA Ultimate onlay/inlay case this afternoon. Tooth 30 had cracked tooth symptom and major cold sensitivity. Horizontal/stained fracture lines at prep axial/pulpal floor distal buccal and lingual cusps. With a solid rim of 1.0-1.5 mm of enamel for retentive bond, Lava adhesively bonded restorations will recapture function requirements for this case. Interesting enough, patient was ecstatic about cold symptoms completely gone after...Read more
Submitted by James Klim DDS, CADStar Host on 01/20/2012 - 11:24am
The soon to be new home of the James Klim practice and CADStar CEREC Training & Mentoring Center is about to happen. My current practice location has been claimed by...Read more
Submitted by James Klim DDS, CADStar Host on 01/08/2012 - 8:55pm
Dr. Kevin Barrett speaks to his experience with CEREC Liftoff Online Training and Mentoring series. For years Dr. Barrett has lectured and taught dental societies, dentists, other colleagues and dental companies always with the emphasis on new directions in dentistry. He has been interviewed and contributed to dental periodicals etc. He created a book for preventive dentistry and done...Read more
Submitted by James Klim DDS, CADStar Host on 01/06/2012 - 1:48pm
There are a few graphic interface adjustments for the new CEREC 4.0 software user. The CEREC workflow is still similar to the prior versions. This video will review the basic workflow assets in the CEREC 4.0 software.
Submitted by James Klim DDS, CADStar Host on 01/01/2012 - 7:32pm
With CEREC 4.0, the cavosurface marginal mills are hitting a home run. This CADStar.org Blog video will review the start position for CEREC 4.0 inlay/onlay parameters. More info and training about CEREC 4.0 can be viewed on my online training and mentoring series called CEREC LIFTOFF....Read more
